Differences

This shows you the differences between two versions of the page.

--- 3dprinter:ender3s1 [2024/01/22 21:13] – [S1/ S1 Pro parts] Wuff
+++ 3dprinter:ender3s1 [2026/05/02 16:59] (current) – [Pause at layer] Wuff
@@ Line 313: / Line 313: @@
 </code>
+===== Pause at layer =====
+Setting pause at height in Cura:
+  * Extensions -> Post Processing -> "Pause at height"
+  * Set Pause at Layer Number to layer to pause at
+  * Set to Malin (M0)
+  * Park Print Head at 190,190 (back right)
+  * Retract 1-2mm
+Prerequisite to support the M0 command in klipper/Sonicpad:
+ssh into sonicpad
+<code>
+vi /mnt/UDISK/printer_config/printer.cfg
+</code>
+add
+<code>
+[gcode_macro M0]
+gcode:
+    PAUSE
+</code>
+then reboot sonic pad