Differences

This shows you the differences between two versions of the page.

--- 3dprinter:ender3s1 [2023/12/09 02:19] – [tuyaplug moonraker] Wuff
+++ 3dprinter:ender3s1 [2026/05/02 16:59] (current) – [Pause at layer] Wuff
@@ Line 75: / Line 75: @@
 https://www.thingiverse.com/thing:5531129/files
 About 1-2mm of overhang from the original connector needs to be removed to prevent the connector from catching the Z Axis motor.
+Hinge bed cable connector:
+https://www.thingiverse.com/thing:5953410
 Ender 3 S1 Flexible flat cable holder by Alei100
@@ Line 156: / Line 159: @@
 https://www.thingiverse.com/thing:5626066
-===== Sonic Pad =====
+====== Sonic Pad ======
 Enable root access:
@@ Line 217: / Line 220: @@
-==== Cura and Klipper/Sonic Pad ====
+===== Cura and Klipper/Sonic Pad =====
 https://www.creality.com/pages/download-creality-sonic-pad
@@ Line 241: / Line 244: @@
 https://www.creality.com/pages/download-creality-sonic-pad
-==== tuyaplug moonraker ====
+===== tuyaplug moonraker =====
 Requires "Moonraker Tuya Generic HTTP Service" as docker or on other system:
@@ Line 294: / Line 297: @@
 #   FIRMWARE_RESTART will be aborted as unnecessary.
 #   The default is False.
-restart_delay: 4.
+restart_delay: 8.
 #   If "restart_klipper_when_powered" is set, this option specifies the amount
 #   of time (in seconds) to delay the restart.  Default is 1 second.
@@ Line 310: / Line 313: @@
 </code>
+===== Pause at layer =====
+Setting pause at height in Cura:
+  * Extensions -> Post Processing -> "Pause at height"
+  * Set Pause at Layer Number to layer to pause at
+  * Set to Malin (M0)
+  * Park Print Head at 190,190 (back right)
+  * Retract 1-2mm
+Prerequisite to support the M0 command in klipper/Sonicpad:
+ssh into sonicpad
+<code>
+vi /mnt/UDISK/printer_config/printer.cfg
+</code>
+add
+<code>
+[gcode_macro M0]
+gcode:
+    PAUSE
+</code>
+then reboot sonic pad