Wulf's Various Things

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== 3D Printer notes ======

Resonance Measurement
configure -> other settings -> Advanced options -> Measuring Resonances
Select printer (moving print bed or static print bed)
connect sensor to sonic pad
Connect sensor to print head via bracket
Test takes about 3 minutes
detach sensor from print head and connect to print bed
sonic pad will reboot

disable slicer acceleration control (cura etc)

klipper added input_shaper section in printer.cfg

# [resonance_tester]                                               
# accel_chip: adxl345                                      
# accel_per_hz: 70
# probe_points:
#      117.5,117.5,10  

[input_shaper]     
#shaper_type_x = mzv
#shaper_freq_x = 56.4                                          
#shaper_type_y = mzv
#shaper_freq_y = 36.2


Pressure Advance
https://www.youtube.com/watch?v=JDis2X-QNZU


 I print everything at around 100mm/s and 3000mm/s accel 
 
 
 
  How To Tune Pressure Advance With Your Sonic Pad - Sonic Pad Intermediate Part 6 
 https://www.youtube.com/watch?v=JDis2X-QNZU
 
 https://moonraker.readthedocs.io/en/latest/configuration/#secrets
 
 Cura & Klipper: How to Make Them Work Together
 https://all3dp.com/2/cura-klipper-tutorial/
 
 https://docs.fluidd.xyz/features/cameras
 




chmod 777 /opt/klipper/run/
docker compose -f docker-klipper.yml up -d
docker exec -ti klipper /bin/bash




    Determine if your printer has Z_HOMING_HEIGHT set. 
	This setting raises the Z-axis on any homing event to avoid collisions. 
	You can check your printer firmware configuration or in a resting state issue the command G28 X0 Y0 in the command terminal and observe if the Z-axis is raised, and by how much. This value is used for Z_HOMING_HEIGHT.
    The Save Frequency setting determines how often the plugin will write the current state information to disk in seconds. Lower values (0.3-0.5) provide greater accuracy at the expense of a greater number of disk writes. Larger values risk missing a greater number of commands.
    Klipper firmware. You must have the [force_move] section with the enable_force_move=true option in your Klipper configuration. Check the appropriate box in the settings. If [safe_z_home] is set, use the z_hop value as Z_HOMING_HEIGHT.
    For other setting information, visit the plugin homepage.




# printer.cfg

[delayed_gcode delayed_printer_off]
initial_duration: 0.
gcode:
  {% if printer.idle_timeout.state == "Idle" %}
    POWER_OFF_PRINTER
  {% endif %}

[idle_timeout]
gcode:
  M84
  TURN_OFF_HEATERS
  UPDATE_DELAYED_GCODE ID=delayed_printer_off DURATION=60