3dprinter:3d-printer-enclosure
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| 3dprinter:3d-printer-enclosure [2023/06/20 04:39] – Wulf Rajek | 3dprinter:3d-printer-enclosure [2023/06/20 04:42] (current) – Wulf Rajek | ||
|---|---|---|---|
| Line 18: | Line 18: | ||
| https:// | https:// | ||
| https:// | https:// | ||
| + | |||
| + | Notes: | ||
| + | - Use the original Lack Table screws for the top Table and plastic connectors | ||
| + | - leg ends without holes for top, use the 2cm screws | ||
| + | - bottom end use 5cm screws (possibly need 7cm) | ||
| + | - 5cm screws for bottom round cones to table | ||
| Line 31: | Line 37: | ||
| 3x 3mm 523x445 Back and Side Panels | 3x 3mm 523x445 Back and Side Panels | ||
| 2x 3mm 523x210 Front Doors | 2x 3mm 523x210 Front Doors | ||
| - | |||
| - | Notes: | ||
| - | - leg ends without holes for top, use the 2cm screws | ||
| - | - bottom end use 5cm screws (possibly need 7cm) | ||
| - | - 5cm screws for bottom round cones to table | ||
| https:// | https:// | ||
| - | |||
3dprinter/3d-printer-enclosure.1687232351.txt.gz · Last modified: by Wulf Rajek