Differences

This shows you the differences between two versions of the page.

--- 3dprinter:3d-printer-enclosure [2023/06/20 04:37] – Wuff
+++ 3dprinter:3d-printer-enclosure [2023/06/20 04:42] (current) – Wuff
@@ Line 18: / Line 18: @@
 https://www.thingiverse.com/thing:4555401
 https://www.thingiverse.com/make:849529
+Notes:
+- Use the original Lack Table screws for the top Table and plastic connectors
+- leg ends without holes for top, use the 2cm screws
+- bottom end use 5cm screws (possibly need 7cm)
+- 5cm screws for bottom round cones to table
-Doorstop on top?
-https://www.thingiverse.com/thing:4607087
 TUSH++ filament spool holder
@@ Line 33: / Line 37: @@
 x 3mm 523x445 Back and Side Panels
 x 3mm 523x210 Front Doors
-Notes:
-- leg ends without holes for top, use the 2cm screws
-- bottom end use 5cm screws (possibly need 7cm)
-- 5cm screws for bottom round cones to table
 https://usbtemp.com/
@@ Line 89: / Line 87: @@
 Easylack Enclosure
 https://www.thingiverse.com/thing:3293248
+Slack Lack Doorstop on top for single piece handles:
+https://www.thingiverse.com/thing:4607087